Polar Lights 1/350 Scale Enterprise NCC-1701 Refit
This version of the famous starship is the refit first seen in Star Trek: The Motion Picture

The model is lighted with a lighting kit built by Trekmodeler.

I am also using photo etch details made by Paragrafix.

Working on landscaping in the arboretum.

Here is the dorsal neck, assembled (though not fully painted), and the upper secondary hull ceiling piece. Lights have been installed and wired between the dorsal neck and the hull piece. You can also see the wire connections that will extend through the pylons to the warp nacelles.

Here are two photos of the completed botanical gardens. The clear ceiling will allow lighting of the arboretrum. The second photo is a side view of what will be showing through the window.

Here is the bottom of the secondary hull, painted and with the main electronics connector installed.

Here is the shuttle bay as seen from the hangar entry.

The model base. Suport rod has not been installed but the base is wired and the two switches are installed. One is the On/Off switch and the other is a toggle to go between "Impulse" and "Warp" mode.

A lot has been done since the last posted photo - the secondary hull is complete (except for marking decals to be applied later) and the main body of the saucer is assembled. At this point, there is painting still to be done on the saucer and then Aztec decals will be applied before the bridge dome is attached. Note that the front of the secondary saucer- the deflector housing and dish - are not attached yet, as I must have access to the wiring inside until the ship is assembled.

Aztecs have been applied to the saucer and the bridge and sensor dome (on the underside) are in place. All that remains are marking decals and some detail painting that will be done when the ship is assembled.

Warp engines have been wired and assembled. Next will come detailing on the nacelles, some painting, and finally the Aztec patterns.

Warp engines attached to the secondary hull.

Saucer attached! I have the ship leaning against the wall in an upright position to let the bond dry overnight.

A little bit closer... Needs saucer marking decals...and the final piece, the deflector dish.